Operating Instructions:
- Clean Surface: Ensure the surface of the bonding substrate is free from dust, rust, and oil.
- Mixture Ratio: Mix according to the weight ratio of 1 to 1. If you need to change the ratio, it should be applied after testing.
- Gluing: Squeeze the sealant onto the cleaned surface.
- Curing: Place the glued part in the air for natural curing. The higher the temperature of the environment, the shorter the working and curing time. Do not heat cure, as it may introduce air bubbles inside the sealant, affecting the bonding and sealing effect.
- Storage: The unused sealant should be immediately tightly sealed. Before using again, a small amount of solidification at the nozzle may occur, but it can be used normally after removal without affecting the product properties.
Storage Conditions:
- Store in a cool and dry place below 35°C.
- Shelf Life: 6 months
Attentions:
- Keep away from children.
- It is recommended to use it in a well-ventilated area to reduce odor.
- If it accidentally comes into contact with the skin or eyes, wipe them clean immediately, then rinse with water and seek medical advice.
- For safety information, please refer to the Material Safety Data Sheet (MSDS).
Packaging Specifications:
- 2600ml / piece, 4 pieces / Carton
Special Note:
The data in this manual were obtained under laboratory conditions. Due to differences in usage environments, users should use these data and conditions for analysis and testing. Vinisili does not guarantee the sales of products and the use of Trimble products under specific operating conditions and assumes no liability for direct, indirect, or accidental losses. If you encounter any problems during use, please contact the Vinisili technical service department for assistance.
