Operating Instructions:
- Clean Surface: Clean the dust, rust, and oil from the surface of the bonding substrate.
- Gluing: Squeeze the sealant onto the cleaned surface.
- Curing: Place the glued part in the air. After skin formation, curing continues inward from the surface. Under 25°C and 55% relative humidity conditions, the sealant will cure to a depth of 2 to 4mm in 24 hours. With prolonged time, the curing depth gradually increases.
- Storage: The unused sealant should be immediately tightened and sealed. Before using it again, remove any crust at the nozzle mouth without affecting normal use. During storage, a small amount of solidification may occur at the nozzle, but it can be used normally after removal without affecting the product properties.
Storage Conditions:
- Store in a cool and dry place below 35°C.
- Shelf Life: 6 months
Attention:
- Keep away from children.
- It is recommended to use it in a well-ventilated area to reduce odor.
- If accidentally touches the skin or eyes, wipe them clean immediately, then rinse with water and seek medical advice.
- For safety information, please refer to the Material Safety Data Sheet (MSDS).
Packaging Specifications:
- 100ml / piece, 100 pieces / Carton.
- 300ml / piece, 24 pieces / Carton.
- 2600ml / piece, 4 pieces / Carton.
Special Note:
The data in this manual were obtained under laboratory conditions. Due to differences in the use environment, users should use these data and conditions for analysis and testing. Vinisili does not guarantee the sales of products and the use of Vinisili products under specific operating conditions and does not assume any liability for direct, indirect, or accidental losses. If the user encounters any problems during use, please contact the Vinisili technical service department for assistance.
